MKC TOOLS New 1 HP Variable Speed DC Motor for 10ER Get the most out of your 10ER Shopsmith with this All New - 1 HP continuous duty DC variable speed motor and controller. Assembled on a custom mounting bracket for the 10E/10ER Shopsmith machine. Completely wired and and with a 10' 14 ga. power cord, ready to plug in and run. For use without a tachometer a motor speed chart is provided. • Motor: 1 HP TEFC 1725 rpm PM DC motor, 10 amps dc, 5/8" shaft. • Controller: KB dc motor controller w/factory heat sink 11 amps dc. • Both motor and controller rated for continuous duty. • RPM range 200 to 2500 rpm. • 10' power cord 14 gauge. • Comes with a 6 month limited warranty on motor and controller. Sales tax applies only if you live in Texas. Available at extra charge: • Locking Reverse switch installed in controller: • motor pulley, trued and balanced: • new high efficiency drive belt for 10E/ER: Contact by Email skip@mkctools.com  Or Call 817-319-2297 ---                                                                   MKC Tools Home