MKC TOOLS New 1 HP Variable Speed DC Motor for 10ER All New - 1 HP continuous duty DC variable speed motor and controller. Assembled on a custom mounting bracket for the 10E/10ER Shopsmith machine. Completely wired and and with a 10' 14 ga. power cord, ready to plug in and run. This model equipped with a Trexon digital tachometer installed in the controller so you will know the exact spindle speed regardless of the belt steps you use. The tachometer can be mounted for horizontal or vertical view as shown in photos below. • Motor: 1 HP TEFC 1725 rpm PM DC motor, 10 amps dc, 5/8" shaft. • Controller: KB dc motor controller w/factory heat sink 11 amps dc. • Both motor and controller rated for continuous duty. • Trexon digital tachometer installed in controller. • RPM range 100 to 2500 rpm. • 10' power cord 14 gauge. • sensor mounting bracket for easy installation on the 10ER • tach transformer installed inside controller • Comes with a 6 month limited warranty on motor and controller. Sales tax applies only if you live in Texas. Available at extra charge: • Locking Reverse switch installed in controller • motor pulley, trued and balanced: • new high efficiency drive belt: Tachometer can be oriented in horizontal or vertical mode Contact by Email skip@mkctools.com  Or Call 817-319-2297 ---                                                                   MKC Tools Home