MKC TOOLS
Not for Sale! Just sharing my find.
I found this old grinder guard in the original box and looks never used.
Although I don't think it was made for the 10ER Shopsmith, it fits very
nicely. The only modifcation I had to make was to mill the slot in the base
mount about 1/8" so the 6" wheel would clear the guard on the back side.
I had to replace the plexiglas shield because the paper was stuck and ruined
the original. I just added a 1/2 x 13 nut and washer on the table raiser
crank to hold the guard in place.
Contact by Email skip@mkctools.com Or Call 817-319-2297 --- Return to List MKC Tools Home |